+ Reply to Thread
Results 1 to 2 of 2

Thread: Dodge HEMI MDS problem

  1. #1
    transman618 is offline Junior Member
    Join Date
    Dec 2010
    Posts
    1

    Default Dodge HEMI MDS problem

    Looking for someone who is familiar with the MDS system in a 06 Charger HEMI. Heres whats going on. Problem happens ONLY on a COLD start and it happens EVERY COLD START. Engine runs like a scalded dog all day long but once the engine is cold again, engine skips again. I have a #1 cylinder misfire code which I have traced to the MDS system.

    Problem: Start engine when cold, within 2 seconds, engine starts skipping, engine will skip for 5 minutes or so then all of a sudden its smooth just like someone turned the #1 cylinder back on with a switch. The reason why I think its the MDS is because I swapped coil packs with #5 and the problem didnt follow to #5. I replaced the #1 injector and the problem persists. Heres the kicker, while standing over the engine compartment when its skipping I hear a loud bang (Like someone hitting the engine block with a wrench) immediately after this bang noise the engine immediately smooths out. Also, when engine is cold and skipping I have no compression on #1. When I hear this bang and the engine immediately smooths out, I have compression and the engine runs flawlessly until the engine is cold again.

    Side note: I ONLY run 5W-20 oil in the engine (Mobil 1 fully synthetic) I know this is critical in the MDS engines.

    Any Dodge techs out there who have seen something like this and can comment??

    thanks,


    transman

  2. #2
    zebracar1 is offline Junior Member
    Join Date
    Dec 2010
    Posts
    5

    Default

    The MDS does not work at idle. It sounds like you have a valve sticking open when it is cold. Once it warms up the tolerances open up and the valve bangs shut again aginst the lifter causing your noise.

+ Reply to Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

1 2 3 4 5 6 7 8 9 10 11 12 13 14